Tundra Wolves
3D printing to the rescue For my Halpi campaign I included a set of light cavalry to my army. That means wolves! The tundra wolves from Mantic, awesome looking and metal as they are, were a little too expensive to make two regiments. I went out to look for some wolves on MyMiniFactory and found me some wolves . These beasts then needed to be printed. After trying to find a service I turned to my friend Maikel who could help me out. Three models, 18 units to go over 75% MMR. That's a lot of the same... No worries, Maikel mirrored the models and suddenly we had 6 models, three each and presto! Primed! Some paint. Better make some friends quick. Ready to go on a base. Basing the beasties The actually most interesting part of this build is the base. Because these regiments are exactly two troops in size and number, we can break them up to use them in other configurations. Thank you Vince for your inspiration on this. What I wanted was to create a whole, that felt like a solid ba...